+49 228 5552576-0


info@predic8.com

Failover for Web Services and HTTP

Using Membrane Router you can setup a high availability cluster of Web Services. But you can also use the router for a cluster of HTTP servers.

Web Services Failover

Figure1: Web Services Failover

How it works

In figure 2 you can see how failover is realized in the Membrane Router. First the HTTPEndpointListener is receiving a request. Next the RuleMatchingInterceptor looks up a matching rule and puts that rule into the exchange data structure. Suppose the rule found is configured with a Loadbalancing interceptor. Then the Loadbalancing interceptor handles the exchange and adds a list of possible destinations. The destinations are ordered according to the dispatching strategy. Now the HTTP client component takes the first destination out of the exchange and tries to send the message to this destination. If a network error occurs, the HTTP client tries again with the next destination.

Failover in Membrane

Figure2: Failover in Membrane

What failures are covered?

Network Failures

Membrane Router handles the following network failures:

Besides these errors other network errors also trigger a failover.

HTTP Failures

It is hard to decide if a HTTP error was caused by a defective service or by a faulty client request. Because of that the router assumes that a HTTP error is normal server behavior and the service is working. In case you need a different behavior please let us know. We are glad to discuss the issue at the Membrane Router Mailing List.

Logging

Set the logging level to debug to see how the router handles a service failure.

Configuration

To setup a high availability cluster of Web Services just configure loadbalancing.

Copyright © 2008-2017 predic8 GmbH
Koblenzerstr. 65, 53173 Bonn, Tel. +49 (228) 555 25 76-0